Data Recovery For Old CNC Machines

Macintosh IIcx Front
Macintosh IIcx
Macintosh IIcx Label
Macintosh IIcx Label

You may be surprised by some of the old computer hardware that’s still used by some companies today. Especially where they are used as the control interface for manufacturing purposes. We recently received a Quantum 40MB SCSI II hard drive from an old Macintosh IICX that was controlling a piece of 7 Ton Fabricating equipment. The software communicated to the CNC equipment through an internal Nubus card with SCSI interface. For the customer it was not just a case of getting the user data off the drive, but to get an exact image so they had a bootable drive with all the relevant software and drivers to run the CNC machine. With our experience in old computer hardware especially old Macs and DOS based PC’s we were able to recover the data from the hard drive and make a bootable replacement drive to get the customer back up and running. For the customer there was no other option but to get his old Macintosh IICX back up and running as new CNC equipment was too expensive to replace.

Old Macintosh & DOS CNC Machines

Macintosh IIcx Bus Error
Macintosh IIcx Bus Error

This is not the first time we have been involved in this sort of request and process. Back in 2008 we had a similar situation with a customer who had a CNC milling machine that was run by an old DOS PC with a Fujitsu M2682TAM hard drive. Again we managed to get a bootable image back to the customer.

So if there is anyone out there running “obsolete” PC’s or Macs, then you know were to come to get the best outcome.

Macintosh IIcx Rear Panel
Macintosh IIcx Rear Panel

Leave a Reply

Your email address will not be published. Required fields are marked *